[ADS 2 Dilution Program Configuration] dialog box

Run the dilution program if you are using ADS 2 Autodilution.

The sample introduction parameters use the parameters set on the Sample Introduction pane.

[Autodilution Factor]

Enter the Autodilution factor.

[Time for Data Acquisition (sec)]

By default, the value of [Total Acq. Time] on the Element Selection pane is set. Change this as necessary.

[Start]

Starts the dilution program. If you are using an autosampler, click [Start], and then specify a vial for the sample.

Signal monitoring starts.

To stop the Autodilution program, right-click and select [ADS 2] - [Stop ADS 2 Dilution Program] from the context menu on the Tune Modes Pane.

[Cancel]

Discards your settings and closes this dialog.

To Get Here

See Also